SR Smith 69-209-028 608 Spring and Fulcrum Assembly – White Finish

What This Part Is Used For
This is a 608 spring and fulcrum assembly used in SR Smith diving board stand setups to provide the board’s pivot point and spring response. It mounts within the diving stand structure under the board where the fulcrum and spring action occur. This version is listed with a white finish to match specific installations.

Why This Part Matters
If the spring or fulcrum components wear, board response can feel inconsistent and hardware can start to loosen or squeak under load. Correct spring and fulcrum geometry helps keep the board stable and predictable over time. Using the wrong assembly can create fitment problems and can compromise how the system sits and performs.

Key Features and Specifications

• Manufacturer part number 69-209-028
• 608 spring and fulcrum assembly
• White finish
• Diving board stand spring and pivot component
• Used in SR Smith diving board stand assemblies

Installation and Fitment Guidance
Install per SR Smith diving stand instructions for the specific 608 system configuration being serviced. Inspect related hardware for wear and replace as needed to restore proper alignment. Confirm by manufacturer part number before ordering.

About the SR Smith Brand
SR Smith diving systems are built around standardized assemblies that support consistent installation and long-term serviceability. Their springs and fulcrum components are spec-driven so facilities can maintain correct geometry over time. Pros rely on SR Smith part numbers to keep replacements accurate and safe.

Common Service Context
Often replaced during diving board refurbishments, deck renovations, or when a board starts to feel loose or inconsistent. Technicians usually identify the correct assembly by the series designation on the stand and the SR Smith part number.