AutoPilot 952-SVC Cell Cable for Nano / Nano+ / Total Control Style Systems

The AutoPilot 952-SVC cell cord connects the Pool Pilot power center or control box to the salt cell. This connection allows the system to send power to the cell so the cell can convert dissolved salt into chlorine.

Because the cord operates in a high-moisture, high-salt, outdoor equipment environment, the connection points can wear over time. Corrosion, loose terminals, heat marks, melting, brittle wiring, or poor contact can create problems that look like a bad cell even when the issue is actually the cable connection.

The AutoPilot 952-SVC Cell Cord is intended for compatible AutoPilot systems that use the Legacy / Nano / Nano Plus / Total Control style cell cord connection. The correct cord is determined by the control box or power center, not only by the salt cell model.

AutoPilot cell cords can be confusing because the cell-side connection may look similar, but the controller-side connection is different. The cord must match the installed control box or power center.

When in doubt, do not guess based on the cell alone. Match the cord to the power center, control box label, and existing cord connection.

Before replacing the cell cord, shut off power to the AutoPilot salt system at the breaker or power source. Disconnect the old cord carefully and inspect the salt cell connection, power center connection, and surrounding equipment area for corrosion, moisture intrusion, heat damage, or loose contacts.

Install the replacement 952-SVC cord only on compatible systems that use this cord style. After installation, confirm the cord is seated securely, restore power, verify proper system operation, and check for any continuing cell, flow, salt, or production-related messages.

What is the AutoPilot 952-SVC cell cord?

The 952-SVC is a replacement salt cell cable used to connect compatible AutoPilot Pool Pilot control boxes to the salt cell. It is commonly used with Nano, Nano Plus, Digital Nano Plus, and Total Control style systems that require the 952 / 952-SVC cord connection.

Is this the correct cord for Pool Pilot Nano or Nano Plus?

Yes, this is the Legacy / Nano / Nano Plus style cord used on compatible AutoPilot Nano and Nano Plus systems that require the 952-SVC cell cable.

Is this the correct cord for Total Control style systems?

Yes, this cord is used on compatible legacy Total Control style systems that require the 952-SVC cell cord. Always confirm your existing power center connection before ordering.

Does this work with Pool Pilot Digital, DIG-220, Generation II, or Evolve?

No. Those systems typically use the Digital / DIG-220 / Gen II / Evolve style cell cord, not this 952-SVC Legacy / Nano / Total Control style cord.

Does the cord depend on the cell model or the control box?

The cord should be selected based on the control box or power center. Multiple AutoPilot cells can use a similar cell-side connection, but the controller-side connection is different between cord styles.

When should I replace my AutoPilot cell cord?

Replace the cord if it shows corrosion, burn marks, heat damage, melting, cracking, loose connection, intermittent operation, or damaged pins. It is also smart to replace the cord when installing a new salt cell if the existing cord is old or questionable.

Can a bad cell cord make my salt cell look bad?

Yes. A weak, corroded, or loose cord connection can cause poor chlorine production, intermittent cell operation, or system errors that may look like a failing salt cell.

What is included?

This listing includes the replacement AutoPilot 952-SVC cell cord only. Salt cell, manifold, power center, sensors, unions, and plumbing components are sold separately unless specifically stated.

How do I confirm fitment?

Match your existing cord part number and controller connection. If you are unsure, send us photos of the power center label, existing cord connection, and salt cell connection before ordering.