SR Smith T7-NSPRING-9 T7 Spring Set with Mounting Hardware – Pair, Gray Finish

What This Part Is Used For
This is an SR Smith T7 spring set used in T7 series spring board stand configurations. It installs under the board within the stand system to provide the spring response and controlled flex expected from the T7 setup. This listing is for a pair and includes mounting hardware, with a gray finish.

Why This Part Matters
Springs that are worn or mismatched can cause uneven response, excess movement, and loosening at the mounting points over time. Replacing the spring set as intended helps restore consistent feel and helps protect surrounding hardware from stress. Incorrect springs can create fitment issues and can compromise stability.

Key Features and Specifications

• Manufacturer part number T7-NSPRING-9
• T7 spring set for SR Smith T7 stand systems
• Pair of springs as listed
• Includes mounting hardware as listed
• Gray finish

Installation and Fitment Guidance
Install following SR Smith T7 system instructions and verify the stand configuration before replacing springs. Check fasteners and mounting points for wear while the assembly is apart. Confirm by manufacturer part number before ordering.

About the SR Smith Brand
SR Smith diving systems are widely serviced using spec-matched replacement parts to maintain correct geometry and predictable performance. Their T-series components are built around standardized assemblies that support long-term upkeep. Using SR Smith part numbers helps technicians avoid incorrect substitutions in safety-critical equipment.

Common Service Context
Commonly ordered during T7 spring rebuilds, board upgrades, or when the board response changes noticeably over time. Technicians typically confirm the correct kit by the T7 designation, finish, and the SR Smith part number.