Hayward SX200Z8A Drain Kit

What This Part Is Used For
The Hayward SX200Z8A is a drain kit used on compatible Hayward sand filters. It provides the drain assembly components needed to drain the filter tank during winterizing, sand changes, and service. This kit installs at the drain port near the bottom of the filter.

Why This Part Matters
A damaged drain assembly can leak continuously or make it difficult to drain the filter cleanly. If the drain components are stripped or cracked, techs often end up with temporary fixes that fail under pressure. Replacing the correct drain kit restores proper sealing and makes routine maintenance easier. It is a common repair when a drain cap will not seal or has been overtightened.

Key Features and Specifications

• Manufacturer part number: SX200Z8A
• Drain kit for compatible Hayward sand filters
• Installs at the filter drain port near the base of the tank
• Used for filter draining during winterizing and service
• Replacement kit for leaking or damaged drain assemblies

Installation and Fitment Guidance
Turn off the pump and relieve all pressure before removing the existing drain components. Verify sealing surfaces are clean and tighten only enough to seal without stripping threads. Confirm by manufacturer part number before ordering.

About the Hayward Brand
Hayward manufactures a complete ecosystem of pool equipment including pumps, filters, heaters, automation controls, cleaners, chlorination products, and service parts. Their filtration systems are widely used and supported with serviceable drain and seal components to keep maintenance predictable. This compatibility helps technicians complete winterizing and spring startup work efficiently. Hayward replacement parts are widely supported across the pool industry.

Common Service Context
Techs typically replace drain kits when a filter drips from the drain port, a cap gasket will not hold, or the drain threads are damaged. It is often discovered during winterizing when the drain is opened and will not reseal afterward.