Hayward SX180K Filter Base With Screws and Washers - For S180T

What This Part Is Used For
The Hayward SX180K is a filter base specified for the Hayward S180T sand filter and is supplied with screws and washers as listed. It supports the filter tank on the equipment pad and helps keep the filter stable and properly positioned. This part sits under the filter and carries the tank load.

Why This Part Matters
A cracked or unstable base can leave the filter sitting uneven, which stresses plumbing connections and can lead to leaks at unions and fittings. Poor support also makes filter service harder and increases the chance of shifting after a sand change. Replacing the base restores stability and proper positioning on the pad. It is commonly replaced after equipment movement, impact damage, or long term UV and weather exposure.

Key Features and Specifications

• Manufacturer part number: SX180K
• Filter base for Hayward S180T sand filter
• Includes screws and washers as listed
• Supports and stabilizes the filter tank on the equipment pad
• Replacement part for damaged or unstable filter bases

Installation and Fitment Guidance
Shut down the system and relieve pressure before disconnecting plumbing or shifting the filter. Set the base on a level surface and ensure the filter sits square before tightening hardware. Confirm by manufacturer part number before ordering.

About the Hayward Brand
Hayward manufactures an integrated ecosystem of pool equipment including pumps, filters, heaters, automation controls, cleaners, chlorination systems, and service parts. Their sand filters are widely used and supported with serviceable structural components to extend equipment life. This compatibility helps technicians keep filtration systems stable and serviceable on residential pads. Hayward replacement parts are widely supported across the pool industry.

Common Service Context
Techs typically replace filter bases when a tank rocks on the pad, the base is visibly cracked, or plumbing alignment is off after equipment has been moved. It is often identified during a rebuild when the filter is already disconnected and the base shows wear or damage.