ProbepH Probe
The pH probe for Aquasol controllers.
ORP and pH probes, an ORP electrode, the flow cell, a safety pressure switch and the small fittings that keep an Aquasol controller reading true.
ProbeThe pH probe for Aquasol controllers.
ProbeThe ORP probe for Aquasol controllers.
SafetyThe safety pressure switch for Aquasol controller setups.
FittingA tube connector from 1/2 inch male pipe thread to 3/8 inch tube.
ElectrodeAn ORP electrode with a 3 foot cable.
DrumA 15 gallon natural poly chemical drum.
Flow cellThe complete flow cell with its fittings, where the probes sit in the sample water.
If readings wander and calibration will not bring them back, the probe is usually due.
Aquasol part numbers are on every listing.
Call 631-678-6506 with your controller model.
Readings drift and calibration no longer brings them back. Call us if you are not sure.
Both are listed by part number: S010 is the ORP probe, AQQS010 is the ORP electrode with a 3 foot cable. Match the one your controller uses.
Yes. Call 631-678-6506 with the part number off your old piece, or send a photo, and we will help you match it.
Tell us the controller model and what it is doing. We will help you find the part.
Aquasol controller parts at Aqua Terra Backyard: ORP probe S010, pH probe S020, ORP electrode with 3 ft cable AQQS010, flow cell with fittings S030, safety pressure switch M011, tube connector F215 and 15 gallon poly chemical drum T715 NAT. Call 631-678-6506 with questions.